CSA certified to ANSI Z21.24/CSA 6.10 and ANSI Z21.75/CSA 6.Deep corrugations enhance flexibility and maneuverability of connector during installation.High tensile strength stainless steel is less susceptible to work hardening.Smooth, burnished connector ends seal with less torque, making installation easier.ProCoat coating corrosion resistant to harsh chemicals as well as UV rays and salt.WRT the above 9/16 is 0.5625 inches, so some minor disagreement there. This one states 0.400 inches for hand tight and 0.5457 for maximum. According to this reference, the pipe should be in the fitting 9/16' for 3/4 NPT threads. Use with natural, manufactured, mixed and liquefied petroleum (LP or propane) gases and LP gas-air mixtures NPT (National Pipe Taper) is designed to be sealable without sealant.Ideal for moderate demand appliances such as 4-burner gas ranges, cook-tops, dryers and water heaters.O.D.) corrugated stainless steel with corrosion resistant coating Consult with a professional installation expert or a plumber to ensure compliance with all applicable codes. This will help create a better seal between two pieces of metal and prevent any leaks from occurring. *Gas connectors may not be permitted for all uses in all locations. If the fitting still seems loose after tightening the connections, then you may want to apply some plumber’s tape (also known as thread seal tape) around the threads of the connection. BrassCraft Video Library Let us show you how Read More. 1/4' ID (3/8' OD) 3/8' ID (1/2' OD) Installing PEX Meet Our Full PEX Lineup Read More. Our black ProCoat® coated gas connectors blend so well they are virtually invisible. This process results in the most complete corrosion resistance available. BrassCraft Gas Appliance Connector Flow Capacity Chart 144.28 KB OctoBrassCraft ProCoat Gas Connector Sell Sheet 1.82 MB JanuBrassCraft ProCoat Large Diameter Gas Connectors Sell Sheet 284.18 KB JanuBrassCraft Gas Appliance and Water Heater Connector Catalog 11. Brass Fittings Needle & Humidifier Valves 5/8 in. The coating is applied only after the connector has been 100% leak tested, prior to nut and fitting assembly. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly onto the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. ProCoat is applied to the corrugated stainless steel connector using advanced powder-coat technology. The proprietary polymer coating is designed to withstand prolonged exposure to harsh household chemicals, UV rays and salt. BrassCraft’s ProCoat stainless steel gas connector is engineered with added safety in mind.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |